Everyone, I enabled the MIR profiles and set the one I am talking about to 25000/5000, the link test shows this speed perfectly, except when we do a speedtest via speedof.me or speedtest.net or anything really, it's only showing 3Mbps.
I have a cambium support ticket open, but that may take a while. I've dug through every setting I can find and can't see anything that would be causing this. Here is the generic layout of my network: SM --><-- AP --> L3 Switch --> BH Radio --> <-- BH Radio --> Switch --> Router --> Internet I've tested the speed (iperf) all the way from my router to my l3 swtich at the tower and I'm getting roughtly 750Mbps avg to the l3 switch. I've tested throughput on the switch as well and I was easily passing 5Gbps through it. I've seen no speed mismatch errors anywhere on the network. Thank You, Jordan Gregory Founder / CEO Hive Wireless, LLC On Thu, Aug 18, 2016 at 11:05 AM, Kerry <[email protected]> wrote: > Here's a couple things to check, > > Check the ap, is MIR under QOS enabled? if so, there should be an entry > under monitor->wireless for the sm showing the rate the sm is 'queued' at. > > The wireless link test will only show it passing roughly what it is queued > at. Also, check the MCS column. If it;s a good link it will be at the max > Rate setting configured > > under the radio config of the ap > > > > On 8/18/2016 11:46 AM, Jordan Gregory wrote: > > Good day list, > > I have a Force 200 operating at very good signal levels but for some > reason, I can seem to get any more than 3Mbps out of the connection. > > Did i miss a setting somewhere? > > Backstory: Brand new wisp > > Thank You, > > Jordan Gregory > Founder / CEO > Hive Wireless, LLC > > >
