What is all of the equipment involved? Have you looked for CRC or FCS
errors on any ethernet links? Unfortunately, the ePMP gear does not have
ethernet CRC errors stats. What about flow control on your GigE interfaces?
Have you ran iperf from behind the SM all the way through to your router?
You say 750Mbps. Are they AirFiber radios? Flow control is what comes to
my mind there. If you have flow control enabled anywhere, turn it off
and see if end-user speed increases. We don't use it because pause
frames cause jitter for VoIP.
On 8/18/2016 10:34 PM, Jordan Gregory wrote:
Everyone,
I enabled the MIR profiles and set the one I am talking about to
25000/5000, the link test shows this speed perfectly, except when we
do a speedtest via speedof.me <http://speedof.me> or speedtest.net
<http://speedtest.net> or anything really, it's only showing 3Mbps.
I have a cambium support ticket open, but that may take a while.
I've dug through every setting I can find and can't see anything that
would be causing this.
Here is the generic layout of my network:
SM --><-- AP --> L3 Switch --> BH Radio --> <-- BH Radio --> Switch
--> Router --> Internet
I've tested the speed (iperf) all the way from my router to my l3
swtich at the tower and I'm getting roughtly 750Mbps avg to the l3
switch. I've tested throughput on the switch as well and I was easily
passing 5Gbps through it.
I've seen no speed mismatch errors anywhere on the network.
Thank You,
Jordan Gregory
Founder / CEO
Hive Wireless, LLC
On Thu, Aug 18, 2016 at 11:05 AM, Kerry <[email protected]
<mailto:[email protected]>> wrote:
Here's a couple things to check,
Check the ap, is MIR under QOS enabled? if so, there should be an
entry under monitor->wireless for the sm showing the rate the sm
is 'queued' at.
The wireless link test will only show it passing roughly what it
is queued at. Also, check the MCS column. If it;s a good link it
will be at the max Rate setting configured
under the radio config of the ap
On 8/18/2016 11:46 AM, Jordan Gregory wrote:
Good day list,
I have a Force 200 operating at very good signal levels but for
some reason, I can seem to get any more than 3Mbps out of the
connection.
Did i miss a setting somewhere?
Backstory: Brand new wisp
Thank You,
Jordan Gregory
Founder / CEO
Hive Wireless, LLC
