Under Config->ServiceFlows->QoS Profiles, do the profiles whose numbers you're using (selected on the Default Parameters page) have HARQ enabled? How many retries?
Under config->Air Interface -> C/N config, what's the C/N Table Base? default -70? On Thu, Oct 6, 2016 at 8:47 PM, That One Guy /sarcasm < thatoneguyst...@gmail.com> wrote: > There is some nutty madness going on on a large portion of our 320 > network, it has hit multiple sites at once. > I know much of its self induced due to too many marginal installs on very > limited access points > > good CINR to SMs, even matrix B I cant even get into to manage. > > uplink MCS for the most part looks good until i get into the frame > utilization, tons of 16qam 1/2 and 100% usage with only 6-12 mbps throughput > > I have been shifting frequencies across the network because it presented > like interference, and a change on one AP results in required cascade > changes across the 3ghz network since 320 sync doesnt actually work. > > APs are basically default layer 2, no profiles changed, 7mhz channels > mostly ABCD 90s and some split APs. sub counts range from 10 to 35 > > I migrated a distant part of the network to 10mhz channels and am not > seeing this issue, but subscriber counts are low > > Im at my wits end on this nonsense and am about to just put every AP on > the network in SA mode to get a visual on what my spectrum looks like > > we did turn up a 450 facing southwest ten miles south of another 320 AP > thats facing south, it blinded the SMs to the 320 on a near channel even > though they were only in the back lobe, but this is far from the others > > any advice from you other guys stuck with wimax would be appreciated > > > -- > If you only see yourself as part of the team but you don't see your team > as part of yourself you have already failed as part of the team. >