Soooo… can I power it off an S16 somehow, with the right cable? (24v?) Paul
From: Af [mailto:af-boun...@afmug.com] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 11:04 AM To: af <af@afmug.com> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device OK found a short .pdf manual. Looks like the 100 series may not support this. The timing port model needs ugps power. On Jun 15, 2017 9:46 AM, "Forrest Christian (List Account)" <li...@packetflux.com<mailto:li...@packetflux.com>> wrote: Hmm. ... odd. I know it's in the 450, but I thought it was in the older radios too. I'm traveling, so can't look it up, but what does the uGPS manual say about FSK radios? On Jun 15, 2017 9:42 AM, "George Skorup" <george.sko...@cbcast.com<mailto:george.sko...@cbcast.com>> wrote: I don't have a single P10 or P11 FSK AP that has UGPS power control on the config page. Perhaps it's just always on? On 6/15/2017 9:35 AM, Forrest Christian (List Account) wrote: AFAIK All semi-modern fsk radios provide uGPS power. Just connect the radio and box together and turn on uGPS power in the radio. Use whatever cable cambium recommends for a uGPS probably just a 6p6c straight through cable, although it might make sense to skip the factory reset pin. On Jun 15, 2017 9:19 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Hmmmm….. let me try again. I have a single FSK AP that is getting powered/ethernet successfully connected to a UBNT S16. I need to get sync to that radio. I want to power the SB Junior Timing Port Version by making a cable that I can connect to the S16 that will connect to one of the SBJTP timing ports to power it up. Unless that ALL FSKs timing ports actually would provide the power needed to power up the SBJTV ? with a “standard” cable whatever that means 😊 Paul From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 10:08 AM To: af <af@afmug.com<mailto:af@afmug.com>> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device What type of fsk radio do you gave that doesn't do ups power? On Jun 15, 2017 9:04 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Syncbox Junior Timing Port Version From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 10:03 AM To: af <af@afmug.com<mailto:af@afmug.com>> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device Which syncbox? On Jun 15, 2017 8:51 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Guys, We need to providing timing on a single FSK AP and it is fed up the tower through fiber to a UBNT S16. (so its powering off the S16). I want to use one timing port to output timing to the FSK (as normal) and one port to receive power from the S16 and need to figure out the pinout (wiring diagram) to make that happen. Paul Paul McCall, President PDMNet, Inc. / Florida Broadband, Inc. 658 Old Dixie Highway Vero Beach, FL 32962 772-564-6800<tel:%28772%29%20564-6800> pa...@pdmnet.net<mailto:pa...@pdmnet.net> www.pdmnet.com<http://www.pdmnet.com> www.floridabroadband.com<http://www.floridabroadband.com>