Cisco 7500 Series Cisco 7200, 2600/3600 Series, and Other Platforms
*Main Interface* Configure a service policy on the main interface Supported only if Frame Relay TS is not enabled and the queueing mechanisms apply to a single interface pipe. *Subinterface* Configure a servicepolicy on the subinterface. Configure a service policy within a Frame Relay map-class and enable per-VC queueing with the *frame-relay traffic-shaping* command. You can apply the map-class to the subinterface. *VC Level* Configure a service-policy within a Frame Relay map-class and enable per-VC queueing with the *frame-relay traffic-shaping* command. You can apply the map-class to the VC. w.r.t VC Level .. it does requires FRTS . check the link in previous mail. i guess ONLY under main interface we can apply CBWFQ . But not on a PVC or a sub-interface. thanks On Wed, Sep 5, 2012 at 12:49 AM, Rob Pool <[email protected]> wrote: > I believe you may be mistaken. I don't believe there is any requirement to > configure FRTS on the interface to use CBWFQ under a map-class. > > Sent from my iPhone > > On Sep 4, 2012, at 5:27 PM, Imran Ali <[email protected]> wrote: > > > guys either my understanding is wrong ..or could be task. > > > > i hope you all understood my query . > > > > On Tue, Sep 4, 2012 at 8:53 AM, Imran Ali <[email protected]> wrote: > > > >> Hi all, > >> > >> i am in VOL 2 LAB 15 . below is the task. > >> > >> configure CBWFQ on R5 interface S0/1/0.2 and PVC between R5 and R6 . > >> The following packets routerd to MPLS core must be allocated a > bandwidth . > >> > >> IPP 5 should be allocated 30 % of bandwidth > >> IPP 4 should be allocated 20 % of bandwidth > >> > >> Ensure the policy map is applied to pvc and not to subinterface. > >> > >> > >> Question : in soluiton we have CBWFQ policy map applied under a > map-class > >> for that pvc . > >> > >> however we know that when enabling CBWFQ on a pvc we MUST have FRTS > >> enabled first . their is no FRTS in solution . > >> > >> from cco : > >> Configure a service-policy within a Frame Relay map-class and enable > >> per-VC queueing with the *frame-relay traffic-shaping* command. You can > >> apply the map-class to the VC. > >> > >> > >> > http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a008009489a.shtml > >> > >> > >> Any ideas guys ? > >> > > _______________________________________________ > > For more information regarding industry leading CCIE Lab training, > please visit www.ipexpert.com > > > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
