Hi, It seems to be that people is not reading properly or my English is not good enough. Arya, the procedure you are telling me I already did it, as you can read on my problem description, it says: I broke out the boot process to delete the config.txt because sometimes the speed console changes when you do an upgrade or whatever via the console, but this time, NOT even in switch: mode is letting me hit enter.
Sent from HP Slate 7 Ramcharan Arya <[email protected]> wrote: Hi, You can change switch BAUD rate by using below procedure. 1. Power off the switch 2. Press the system button and power on the switch and keep system button hold for 30 sec type flash_init load_helper delete configuration file reset the switch change baud rate on switch as per below procedure http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#download_2620 This will allow you to change buad rate to 9600 so you can see logs on hyper term session. Thanks, Ramcharan Arya CCIE # 28926 ( Voice/Routing & Switching) On Sat, Nov 9, 2013 at 12:22 PM, Wilberth E. Lemaître < [email protected]> wrote: > Hello Community, > I am having a strange issue with my Switch 3550. I updated the IOS and I > changed the Console BAUD to 115200 then I put it back to 9600 when the > upgrade was successful. I turned it on ago normally and now either 115200 > or 9600 speed is not working, I tried SecureCRT, putty, I changed the > console cable, everything. The weirdest thing is that when I set the speed > in 9600 in SecureCRT or putty, I can see while the switch boots up which > means the switch is working perfectly but when it says press RETURN to get > started I hit enter and nothing happens, absolutely nothing. I broke out > the boot process to delete the config.txt because sometimes the speed > console changes when you do an upgrade or whatever via the console, but > this time not even in switch: mode is letting me hit enter. I know the > switch is working properly because if I connect a cable to f0/0 I can see > the logging message on my screen when it comes up (this is in 9600 speed in > SecureCRT) Now, is there any other way t > o reset the BAUD of the console? Any other idea to get into the switch? > Or if this is a bug, how can it be solved? > Best regards,Wilberth > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
