In this case it seems problem is related to flow control. You should try flow control on/off.
Have you tried windows hyperterm application apart from putty and securecrt.? On Sat, Nov 9, 2013 at 8:27 PM, Wilberth LeMaître < [email protected]> wrote: > Hi, > > It seems to be that people is not reading properly or my English is not > good enough. Arya, the procedure you are telling me I already did it, as > you can read on my problem description, it says: I broke out the boot > process to delete the config.txt because sometimes the speed console > changes when you do an upgrade or whatever via the console, but this time, > NOT even in switch: mode is letting me hit enter. > > > Sent from HP Slate 7 > > Ramcharan Arya <[email protected]> wrote: > > Hi, > > You can change switch BAUD rate by using below procedure. > > 1. Power off the switch > 2. Press the system button and power on the switch and keep system button > hold for 30 sec > > type > flash_init > load_helper > delete configuration file > > reset the switch > > change baud rate on switch as per below procedure > > > > http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#download_2620 > > This will allow you to change buad rate to 9600 so you can see logs on > hyper term session. > > Thanks, > Ramcharan Arya > CCIE # 28926 ( Voice/Routing & Switching) > > > > On Sat, Nov 9, 2013 at 12:22 PM, Wilberth E. Lemaître < > [email protected]> wrote: > > Hello Community, > I am having a strange issue with my Switch 3550. I updated the IOS and I > changed the Console BAUD to 115200 then I put it back to 9600 when the > upgrade was successful. I turned it on ago normally and now either 115200 > or 9600 speed is not working, I tried SecureCRT, putty, I changed the > console cable, everything. The weirdest thing is that when I set the speed > in 9600 in SecureCRT or putty, I can see while the switch boots up which > means the switch is working perfectly but when it says press RETURN to get > started I hit enter and nothing happens, absolutely nothing. I broke out > the boot process to delete the config.txt because sometimes the speed > console changes when you do an upgrade or whatever via the console, but > this time not even in switch: mode is letting me hit enter. I know the > switch is working properly because if I connect a cable to f0/0 I can see > the logging message on my screen when it comes up (this is in 9600 speed in > SecureCRT) Now, is there any other way t > o reset the BAUD of the console? Any other idea to get into the switch? > Or if this is a bug, how can it be solved? > Best regards,Wilberth > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
