The problem is probably with the version of hyperterm you're using. Get
teraterm or get update from MS site and control-break should then work.
"George H. York" wrote:
> http://www.cisco.com/warp/public/474/index.shtml
> You will find everything you need here.
> Good Luck,
> George H. York
> CNE, CCNA
>
> Robert McIntire wrote:
>
> > I'm working with a used 2514 router with an unknown enable password.
> > I've tried the standard break technique but can't abort the boot
> > sequence. I believe that break may be disabled. I'm using Win NT 4
> > and hyperterminal to connect to the console port and am able to
> > connect and SHOW VERSION. I am getting terminal feedback. I've used
> > CTRL-BREAK AND CTRL-SHFT-6 to no avail. How can I access ROMMON mode
> > and change the password? Is there a jumper on the system board that
> > can be used to circumvent the password and access the router for
> > configuration? Any advice is appreciated, Thanks
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]