Our main facility (Los Angeles) has a T1 FR with Pacbell (SBC). In the seven months I have been running the the IT department, I have seen the T1 go down twice. Once was due to the re-routing of the phone lines that come into the building. The building is 70 years old, and the lines used to come in underground and now come in above ground. This was done in June, and I can see how this would cause some grief. The second time was in November, and SBC admitted the problem but gave no reasons. Service was unavailable for one hour.
One of our remote sites (Cincinnati) had a 128K FR with Williams Communications. This was installed before I was responsible for network. Other than the initial startup problems (which I was told lasted about four months), the line seemed to run flawlessly. The connection between the two offices was run on the "private" SBC backbone ... I.E. - the Cincinnati traffic to the Internet ran through our T1 line here LA, then back out the same T1 line to the Internet. It was pretty ugly. Even worse than that, the cost of the 128K FR from Williams was almost equal to the T1 line from SBC. I switched this remote site to DSL from Cincinnati Bell, and connect to the main site through a VPN. They get 560kB/s down and 350kB/s up. As they have nothing that is mission critical and the company will never cough out for VoIP, it is perfect for them. Over the course of six months, the DSL service was unavailable once, and was restored within an hour. The biggest delta is the price. While I am on the subject, you may enjoy a good laugh. This company is privately owned, and had a teletype until 1995. They only got rid of it because Pacbell said it was no longer supported. Email was not implemented until the Summer of 1999. Justin From: "Ole Drews Jensen" Reply-To: "Ole Drews Jensen" To: [EMAIL PROTECTED] Subject: Anyone Higher? - FR Uptime [7:30920] Date: Fri, 4 Jan 2002 09:31:57 -0500 During the years I have been administering frame relay, I have been dealing with four different providers and four different telco's, but I have so far not seen any circuit being up for a long time without problems. I believe that the longest I have seen a f.r. circuit being up is about a little less the half a year, and one of our providers had an average of downing one of our circuit every 1.5 months. We have four circuits (three branch offices and one corp.) with a provider, and all three branch offices has now been down once (at different dates) in less than four months. So, I am looking for a possitive story in the Frame Relay world. Who can with a smile tell me about a frame relay connection that has been up for a year or more - or would that be totally sci-fi??? I am getting SOOOOOOOOO frustrated and irritated that I have to deal with so much trouble with "simple" WAN connections. Thanks, Ole ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Ole Drews Jensen Systems Network Manager CCNP, MCSE, MCP+I RWR Enterprises, Inc. [EMAIL PROTECTED] ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ http://www.RouterChief.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ NEED A JOB ??? http://www.oledrews.com/job ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ _________________________________________________________________ Join the worlds largest e-mail service with MSN Hotmail. http://www.hotmail.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=30951&t=30920 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]