On Wednesday 05 March 2008, Stuart Stevenson wrote: >Gentlemen, > Does anyone have a procedure for starting (correctly) in the >middle of a program? >thanks >Stuart
About the only way I've been able to bypass steps that have already been done, is to set 2 identical vars for the starting location at the top of the program, with one set at 0.00 and the other commented out. Then if I break a bit or have some other problem that requires the resetting of the 0.00 points, I'll reset those and re-home them, then switch vars by setting the second of to the depth I had achieved, and comment out the 0.00 starter setting. Works great for drilling big holes and such with a 1/4 end mill. >------------------------------------------------------------------------- >This SF.net email is sponsored by: Microsoft >Defy all challenges. Microsoft(R) Visual Studio 2008. >http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ >_______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) The hatred of relatives is the most violent. -- Tacitus (c.55 - c.117) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
