On Thu, 2008-03-13 at 14:19 -0500, [EMAIL PROTECTED] wrote: > > On Wednesday 12 March 2008, [EMAIL PROTECTED] wrote: > >>I hope it's not too off-topic, as it's not about EMC2, but this is a ... snip > to push air through the zig-zag channel. Maybe I could even run a pipe in > there from my portable A/C unit to blow out the heat. > > Anyway, thanks for the info! > -Gary
You could build a slightly smaller room within your office and suspend the corners on soft rubber. ;) -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
