Hi all, Just to confuse the issue: has anyone done electrolytic polishingd/ deburring.
It should work fine with diluted sulfuric acid for steel of stainless steel but on aluminum you probably get both deburring and anodizing. Not that that is bad if you don't want a bright surface. Just thinking out-loud. I did find one reference to electropolishing in various alkali hydroxides. Aluminum is amphoteric so you can etch it with either a base or an acid. You will need ventilation because of the hydrogen given off. Dave On Mar 13, 2008, at 12:40 PM, [EMAIL PROTECTED] wrote: >> On Thu, 2008-03-13 at 14:19 -0500, [EMAIL PROTECTED] wrote: >>>> On Wednesday 12 March 2008, [EMAIL PROTECTED] wrote: >>>>> I hope it's not too off-topic, as it's not about EMC2, but this >>>>> is a >> ... snip >>> to push air through the zig-zag channel. Maybe I could even run a >>> pipe >>> in >>> there from my portable A/C unit to blow out the heat. >>> >>> Anyway, thanks for the info! >>> -Gary >> >> You could build a slightly smaller room within your office and >> suspend >> the corners on soft rubber. ;) >> -- >> Kirk Wallace (California, USA >> http://www.wallacecompany.com/machine_shop/ >> Hardinge HNC lathe, >> Bridgeport mill conversion, doing XY now, >> Zubal lathe conversion pending) > > I like your lateral thinking. Now I'm thinking it would probably be > even > easier to just burn all of my neighbor's houses down ;) > > -Gary > > > ---------------------------------------------------------------------- > --- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
