> On Thu, 2008-03-13 at 14:19 -0500, [EMAIL PROTECTED] wrote: >> > On Wednesday 12 March 2008, [EMAIL PROTECTED] wrote: >> >>I hope it's not too off-topic, as it's not about EMC2, but this is a > ... snip >> to push air through the zig-zag channel. Maybe I could even run a pipe >> in >> there from my portable A/C unit to blow out the heat. >> >> Anyway, thanks for the info! >> -Gary > > You could build a slightly smaller room within your office and suspend > the corners on soft rubber. ;) > -- > Kirk Wallace (California, USA > http://www.wallacecompany.com/machine_shop/ > Hardinge HNC lathe, > Bridgeport mill conversion, doing XY now, > Zubal lathe conversion pending)
I like your lateral thinking. Now I'm thinking it would probably be even easier to just burn all of my neighbor's houses down ;) -Gary ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
