Peter Wallace wrote: >>Also the: setp watchdog.timeout_ns line is commented out
>>Perhaps someone thought that the watchdog would be disabled if this value is >>not set. >>I think with the current driver, the watchdog cannot be disabled, probably a >>good thing... >>So at least the first fix is to uncomment the two watchdog related lines in >>m5i23.hal In my PRE-2.2.8 TESTING setup, performing anything with the watchdog on the HM2 7i43 caused errors, hence its inclusion, but being commented out. For the sake of function, I just assumed that portion of the driver wasn't completed yet. (Keep in mind this was back in October '08). Significant improvements have been made to the drivers and firmware since then. Those hal configs weren't tested on a 5i2x (or anything else for that matter) on my setup, as at the time all I had were the 7i43s. Since the 5i20 is the more mature hardware, one could conclude that the 'dog function is completely capable. Side note also that the 5i2x has additional, separate thread calls for gpio (can't recall if you're using them) - that the 7i43 file doesn't use currently (IIRC, per Peter, due to EPP timing restrictions). Ted. ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
