Thanks, Jeff, I hope some time I will know what I'm doing...
Peter

At 14:20 26.01.2009, you wrote:
>starting from a stepconf file, you need to at least
>* delete all the parport.0.pin-##-out-reset lines in your hal file
>* delete the 'addf parport.0.reset' line in your hal file
>* delete the 'setp parport.0.reset-time' line in your hal file
>* set the steplen and stepspace parameters to datasheet numbers in ns
>to disable the "doublestep" mode and get the long step pulse lengths
>that are required for your driver board.
>
>Jeff
>
>------------------------------------------------------------------------------
>This SF.net email is sponsored by:
>SourcForge Community
>SourceForge wants to tell your story.
>http://p.sf.net/sfu/sf-spreadtheword
>_______________________________________________
>Emc-users mailing list
>Emc-users@lists.sourceforge.net
>https://lists.sourceforge.net/lists/listinfo/emc-users


------------------------------------------------------------------------------
This SF.net email is sponsored by:
SourcForge Community
SourceForge wants to tell your story.
http://p.sf.net/sfu/sf-spreadtheword
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to