On Mon, 2011-11-07 at 20:15 -0600, Kasey Matejcek wrote: > Has anyone tried to use and RC controller with EMC to run a RC brushless > motor > They take a pwm control signal from 1ms to 2ms or around there but haven't > tried > It sound like the have to have a signal on the input when there powered up > or the go into disable mode possibly
I posted a little bit of RC servo stuff here: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?RC_Servo_Test I suppose an RC ESC uses the same type of signal. http://www.youtube.com/watch?v=fPLdHeRQp_w Since an RC brushless motor is just a three phase motor this link might be of interest too: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?BLDC but in this setup EMC2 fills the ESC role. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
