On Fri, 11 Jul 2014, Gene Heskett wrote: > Date: Fri, 11 Jul 2014 14:57:32 -0400 > From: Gene Heskett <[email protected]> > Reply-To: "Enhanced Machine Controller (EMC)" > <[email protected]> > To: [email protected] > Subject: Re: [Emc-users] Where to get latest PncConf? > > On Friday 11 July 2014 14:45:45 Peter C. Wallace did opine > And Gene did reply: >> On Fri, 11 Jul 2014, Gene Heskett wrote: >>> I can do that without a lot of problems I think. >>> >>>> to read your current configurations pinout >>>> >>>> >>>> Here's the latest mesaflash source: >>>> >>>> https://github.com/micges/mesaflash/archive/master.zip >>> >>> IOW Peter, I'll have to rip up the current BOB wiring. I was hoping >>> it was a matter of moving the db25 connector on the rear of the >>> machine. >> >> Probably not, one of the existing pinouts should be close wo what you >> need (thats a good reason to read the .pin files that come with the >> 5i25.zip file) >> >> If no existing pinout is close enough its easy enough for me to make a >> custom one (only a few minutes) >> >>> I'll print this, and go get it on that box. gunzip works on that .zip >>> file I'd assume. >>> >>> What I will do is reconfigure my BOB to try & match the 5i25 pin >>> outs. The .hal files won't match when I move the plug, but I'll see >>> how much schmardter I can get doing it. >> >> It surely will not match a parallel port hal file >> the stepgen and PWM numbers can be made to match however > > I could not select a different pwmgen pin, and no stepgen dir outputs were > shown when I did select one. All sorts of BLDC stuffs yes, but not > stepgens.
You will not be able to change PWM pins as this is determined by the FPGA configuration (or what pncconf thinks the FPGA configuration is), What I menat is that I can easily change the FPGA pinout and where PWM outputs are for example, but unless your current FPGA config is one that supported by pncconf you will have issues Why not just start with an example hal file like hm2-stepper.hal? > >>> Back later, I promise, unless I get dead or something. >>> >>> Thanks Peter. >>> >>> Cheers, Gene Heskett >>> >>> --------------------------------------------------------------------- >>> --------- _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> Peter Wallace >> Mesa Electronics >> >> (\__/) >> (='.'=) This is Bunny. Copy and paste bunny into your >> (")_(") signature to help him gain world domination. >> >> >> ----------------------------------------------------------------------- >> ------- _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > US V Castleman, SCOTUS, Mar 2014 is grounds for Impeaching SCOTUS > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
