I did input > # Read home switch inputs from I/O card. net x-home-sw <= hm2_[HOSTMOT2](BOARD).0.gpio.026.in net y-home-sw <= hm2_[HOSTMOT2](BOARD).0.gpio.030.in net z-home-sw <= hm2_[HOSTMOT2](BOARD).0.gpio.034.in
and this # Connect home switch nets to motion. net x-home-sw => axis.0.home-sw-in net y-home-sw => axis.1.home-sw-in net z-home-sw => axis.2.home-sw-in ############################# error was hm2 servo 'net' requires at least one pin, none given 1993 what part 1993 means? and after i put # at front of 2nd part number change to 2257 On Wed, Jul 16, 2014 at 12:44 PM, Philipp Burch <[email protected]> wrote: > Hi Aram! > > On 16.07.2014 21:30, a k wrote: > > Hi Philipp > > About > > > > ---------- -------------- -------------- > > # Read home switch inputs from I/O card. > > net x-home-sw <= m5i20.0.in-02 > > net y-home-sw <= m5i20.0.in-06 > > net z-home-sw <= m5i20.0.in-10 > > > > # Connect home switch nets to motion. > > net x-home-sw => axis.0.home-sw-in > > net y-home-sw => axis.1.home-sw-in > > net z-home-sw => axis.2.home-sw-in > > ------------------------------------- > > ####################################### > > what about HOMING code that came as a default - from installation-- > > > > net home-switch <= hm2_[HOSTMOT2](BOARD).0.gpio.025.in_not > > net home-switch => axis.0.home-sw-in > > net home-switch => axis.1.home-sw-in > > net home-switch => axis.2.home-sw-in > > ######################################### > > delete it/alter--something should be > > 1st line need remove because of 025 and i use 2-6-10-and remaining part? > > > > You can just replace the posted example code by the above. Have you even > tried to figure out what the example code does differently than what I > wrote? If you see that, then you have at least a basic understanding of > HAL and should be able to modify most of the example configuration to > suit your machine. But again, I never worked with Mesa cards, so I don't > know how they are exactly named in HAL (check the first line of your > posted excerpt, that might give you a hint). And I especially do not > know if the pin numbers are correct. > Check Peters answer(s), he's the Mesa Guru. > > Best regards, > Philipp > > > > ------------------------------------------------------------------------------ > Want fast and easy access to all the code in your enterprise? Index and > search up to 200,000 lines of code with a free copy of Black Duck > Code Sight - the same software that powers the world's largest code > search on Ohloh, the Black Duck Open Hub! Try it now. > http://p.sf.net/sfu/bds > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ Want fast and easy access to all the code in your enterprise? Index and search up to 200,000 lines of code with a free copy of Black Duck Code Sight - the same software that powers the world's largest code search on Ohloh, the Black Duck Open Hub! Try it now. http://p.sf.net/sfu/bds _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
