On 11/12/2014 11:31 AM, Gene Heskett wrote: > On Wednesday 12 November 2014 10:56:50 Dave Cole did opine > And Gene did reply: >> Magnets like that were used on a waterjet I was working on to keep >> parts from falling in the tank as the machine cut them out. >> >> I used paper towel to wipe off fillings from the cutting process. I >> think a rag might work better. >> >> Dave > These are VERY seriously strong. Jim had one stuck to the light gauge > steel of a filing cabinet, and it took both hands & a brace his knee > against the cabinet to slide it sideways off the edge of the cabinet. A > straight pull? No way `Jose. Stuck to the top, it could have easily > picked up the cabinet without unloading the several hundred pounds of its > contents.
These magnets are the same way. They are about an inch in diameter and they put them over the cut line to keep plate steel (like 3/8"-1/2" plate) from falling in the tank. You don't pull them off, you slide them off an edge. I've never seen a stronger magnet. Dave --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com ------------------------------------------------------------------------------ Comprehensive Server Monitoring with Site24x7. Monitor 10 servers for $9/Month. Get alerted through email, SMS, voice calls or mobile push notifications. Take corrective actions from your mobile device. http://pubads.g.doubleclick.net/gampad/clk?id=154624111&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
