Andy, Can I open another terminal to run halcmd show all? Or do I need to run that from inside Linuxcnc?
Rick On 4/14/2015 7:34 AM, andy pugh wrote: > On 14 April 2015 at 12:21, Rick Lair <r...@superiorroll.com> wrote: >> I have made good head way since yesterday, communicating thru the new >> NIC card, on modified IP thru eeprom. I have my config up and running, >> can see all my hal signals I created, except the pwmgen's, > I would hazard a guess that the 7i80 uses analogue outputs rather than > pwmgens. > > If you get the 7i80 on-line then open a terminal and: > halcmd show all > then you will get a list of all the pins. I think you will see > ...analogout.00 etc insted of pwmgens. > -- Thanks Rick Lair Superior Roll & Turning LLC 399 East Center Street Petersburg MI, 49270 PH: 734-279-1831 FAX: 734-279-1166 www.superiorroll.com ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
