------ Original Message ------ From: "andy pugh" <bodge...@gmail.com> To: "Marius Liebenberg" <mar...@mastercut.co.za>; "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: 2015-04-14 14:42:57 Subject: Re: [Emc-users] 7i80 Setup ( Was PNCConf setup)
>On 14 April 2015 at 13:27, Marius Liebenberg <mar...@mastercut.co.za> >wrote: >> It depends on what daughter cards are connected and if you use a >>sserial >> expansion card. As far as I know the standard firmware that it comes >> with is good enough for most configurations but I had to load >>something >> else due to the fact that I fitted a 7i44 and my firmware was old. > >That rather depends on what "standard" firmware you have. > >From what Rick says later it looks like "rmsvss6_8.bit" > True, I was referring to the base firmware that the unit comes with. There is a long list of possible configurations under the firmware directory to match every possible card. The configuration firmware is loaded at runtime. >That does appear to have PWM modules, on pins 11 to 23 of the first >connector. >http://git.linuxcnc.org/gitweb?p=hostmot2-firmware.git;a=blob;f=PIN_RMSVSS6_8_72.vhd;h=833d718d316c690eaaf5bb3bfe6ec84bcc56ef89;hb=HEAD > > >-- >atp >If you can't fix it, you don't own it. >http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
