On Sunday 10 May 2020 12:32:47 Ed wrote: > On 5/9/20 1:43 PM, Peter C. Wallace wrote: > > On Sat, 9 May 2020, Ed wrote: > >> 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc > >> pfifo_fast > > > > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ > > > > you need to change your interfaces file to setup eth0 not eth1 > > > > > > > > Peter Wallace > > Mesa Electronics > > OK got that done and renamed 7i80HD to 7i80 in the ini file and > Linuxcnc starts up fine. Thanks for the info!! > > > Now the DRO would only read up and down one encoder count so I figured > it was a setup problem. The LED's on the 7i29's are set to show > encoder counts and show them as working properly. Then I looked at the > setup screen on PNCconf and compared it to the connector pinout in the > 7i29 manual and see that they are a mismatch. > > The question is, what file(s) do I change to correct this? > > That s/b nothing but straight edits of the .hal file. Use almost any editor except gedit which may be setup in the .ini file. It scrambles file contents now and again.
geany is a dependable replacement. So fix the .ini file and install geany and friends. Then fix the .hal file. > Ed. > > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users