On 5/10/20 5:39 PM, Peter C. Wallace wrote:
On Sun, 10 May 2020, Ed wrote:
Date: Sun, 10 May 2020 16:43:34 -0500
From: Ed <ate...@mwt.net>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] Trouble setting up a 7I80HD
On 5/10/20 11:51 AM, Peter C. Wallace wrote:
This likely means that you do not have the proper bitfile loaded.
Thats really should be the first step before any testing, make sure
the the pinout of the configuration matches you daughterboard setup.
A svst4_8 of svst8_4 configuration is a suggested.
Setup completes and Linuxcnc starts with either SV12 or SVST4_8 as
long as 7i80HD gets edited to7i80.
Ths list you show does not match either sv12 or svst4_8
did you first flash the 7I80HD-16 with the appropriate firmware?
mesaflash --device 7i80 --write 7i80hd_16_sv12.bit mesaflash --device
7i80 --reload
mesaflash --device 7i80 --write 7i80hd_16_sv12.bit did not work
because no path, added the path to the .bit file and got;
checking file.......error:IO error
Is there a specific place to put the.bit file? What would cause IO
error? When it gets to Linux CL I start getting lost, so used to O/S2.
Thanks, Ed.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users