On Sun, 10 May 2020, Ed wrote:

Date: Sun, 10 May 2020 11:32:47 -0500
From: Ed <ate...@mwt.net>
Reply-To: "Enhanced Machine Controller (EMC)"
    <emc-users@lists.sourceforge.net>
To: emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] Trouble setting up a 7I80HD

On 5/9/20 1:43 PM, Peter C. Wallace wrote:
On Sat, 9 May 2020, Ed wrote:


2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

you need to change your interfaces file to setup eth0 not eth1



Peter Wallace
Mesa Electronics


OK got that done and renamed 7i80HD to 7i80 in the ini file and Linuxcnc starts up fine. Thanks for the info!!


Now the DRO would only read up and down one encoder count so I figured it was a setup problem. The LED's on the 7i29's are set to show encoder counts and show them as working properly. Then I looked at the setup screen on PNCconf and compared it to the connector pinout in the 7i29 manual and see that they are a mismatch.


This likely means that you do not have the proper bitfile loaded. Thats really should be the first step before any testing, make sure the the pinout of the configuration matches you daughterboard setup. A svst4_8 of svst8_4 configuration is a suggested.




The question is, what file(s) do I change to correct this?


Ed.




_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users


Peter Wallace
Mesa Electronics

(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to