On 07/21/2020 10:15 AM, Matthew Herd wrote:
Ahh, so I do use limit switches and a homing routine. So it’s homing to the
same position (plus or minus a few thousandths or so).
So, use the # key to show machine coordinates, and then move
the Z to the safe limits of travel, and note the Z values.
Then, put these values into the .ini file for MAX_LIMIT and
MIN_LIMIT. Then, try to jog beyond those limits and observe
if the machine makes a controlled stop at those points. If
so, you now have the soft limits set right. Then, try the
G33.1 again and see if the issue still happens.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users