Oh and this is the project. Butterfly Impact wrench power draw bar.
> -----Original Message----- > From: marcus.bow...@visible.eclipse.co.uk > [mailto:marcus.bow...@visible.eclipse.co.uk] > Sent: September-15-21 10:57 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Safely Upgrading LinuxCNC > > On 2021-09-15 23:29, John Dammeyer wrote: > > I have too much other stuff installed on that PC to want to re-install > > the OS with a new version that included LinuxCNC 2.8. > > > Good point. I run a single dedicated PC for each machine. I also have > swappable C:/ and D:/ drives, so I can preserve the old drives until I > am happy with a new installation. I must admit I am slow to upgrade, so > problems have usually been ironed out before I move to a new major > version. > > Marcus > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
