On Thursday 16 September 2021 02:29:05 John Dammeyer wrote: > I just ran the mill this evening for a while facing off the two sides > of a casting. Tomorrow I'll mount it and run the G-Code to profile > the outside and drill the 3 holes. The only odd thing that hasn't > happened before is the Pendant stopped working. Given that the > spindle on/off also no longer works the biggest fatality so far in > this upgrade is the pendant. > The spindle control loss is not something I've ever encountered in an update.
Are you doing something unusual? I have 2 1hp rated pmdc I'm running with modified Jon's pwm-servo's, pushing then to around 2hp, and 2 1+ hp rated vfd's, one run over an rs485 link and one run by a Spinx1. I have a pendant, came with the 6040. USB interface, no jog dial so I've never plugged it in while lcnc was running. Designed for mach, it didn't work with that either. So I just take the wireless keyboard to the machine. > Which is one of the reasons I've resisted upgrading. How many days of > mucking around will it cost to fix something that wasn't broken other > than trying to bring the AMD64 upto the same revision as the Pi4. > > > -----Original Message----- > > From: marcus.bow...@visible.eclipse.co.uk > > [mailto:marcus.bow...@visible.eclipse.co.uk] Sent: September-15-21 > > 10:57 PM > > To: Enhanced Machine Controller (EMC) > > Subject: Re: [Emc-users] Safely Upgrading LinuxCNC > > > > On 2021-09-15 23:29, John Dammeyer wrote: > > > I have too much other stuff installed on that PC to want to > > > re-install the OS with a new version that included LinuxCNC 2.8. > > > > Good point. I run a single dedicated PC for each machine. I also > > have swappable C:/ and D:/ drives, so I can preserve the old drives > > until I am happy with a new installation. I must admit I am slow to > > upgrade, so problems have usually been ironed out before I move to a > > new major version. > > > > Marcus > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users