I'll buy 2 to get you started!
-----Original Message----- From: flexradio-boun...@flex-radio.biz [mailto:flexradio-boun...@flex-radio.biz] On Behalf Of Tim Ellison Sent: Monday, August 24, 2009 6:54 PM To: Ray J; FlexRadio@flex-radio.biz Subject: Re: [Flexradio] V/U Upgrade No. It has to use the Firewire/ADC/DAC/TCXO interface on the FLEX-5000 TRX board to operate. Market research shows that V/U only, all mode radios are just too small of a market share to justify the development expense. -Tim -----Original Message----- From: flexradio-boun...@flex-radio.biz [mailto:flexradio-boun...@flex-radio.biz] On Behalf Of Ray J Sent: Monday, August 24, 2009 6:03 PM To: FlexRadio@flex-radio.biz Subject: Re: [Flexradio] [SPAM] Re: V/U Upgrade So are there any future plans to make the V/U Upgrade "module" into stand alone device then ?? w9Ray Tim Ellison wrote: > Ray, > > You are 100% correct. The upgrade that was initially slated as a transverter was changed based on user input to a high power unit and is no longer a transverter upgrade, but as you correctly stated, a VHF/UHF expansion module. > > > -Tim > > -----Original Message----- > From: Ray Andrews, K9DUR [mailto:k9...@rnacs.com] > Sent: Monday, August 24, 2009 2:11 PM > To: Tim Ellison; 'Ray'; kb...@starband.net; FlexRadio@flex-radio.biz > Subject: RE: [Flexradio] [SPAM] Re: V/U Upgrade > > And, while we are on the topic, people have been referring it as a > transverter. I believe I am correct in stating that it is not a > transverter, per se, but actually an expansion module to extend the > hardware to 144 MHz & 432 MHz. The difference being that a > transverter simply heterodynes (translates) the signals down to an RF > IF frequency, typically > 28 MHz, where the normal radio hardware/software takes over. Whereas with an expansion module, the 144 MHz & 432 MHz signal processing will use the same direct-conversion techniques like the radio does on HF/6m. > > 73, Ray, K9DUR > http://k9dur.info > > > > > > _______________________________________________ > FlexRadio Systems Mailing List > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flex-radio.com/ Homepage: > http://www.flex-radio.com/ Message delivered to r...@w9ray.org > ---------------------------------------------------------------------- > -- > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 8.5.409 / Virus Database: 270.13.65/2323 - Release Date: > 08/24/09 06:05:00 > > _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to telli...@itsco.com _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to ve...@cogeco.ca No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.392 / Virus Database: 270.13.65/2323 - Release Date: 08/24/09 12:55:00 _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to arch...@mail-archive.com