Tim, I was looking at your idea of 6 or 8 sided block's, I figured with a 10 inch radius using 6 sides the largest part you could use would be about 3.5 to 3.75 inches,and if you were to use 1.5 inch lumber the block would end up being about 6.75 inches, with this it would only cut about 1/4 inch off the part, are these the same figures you cam up with? Now the truth is with the same size and a 4 sides block you would still end up with the same amount cut off the board,but you could use a larger board. If this is the cut you want, and the width you want this would save time but the cost would be width of the board.
I would think in order to figure a size out would be to find the dimensions of wood they want to start with, how thick they want the sides to be when finished and the capabilities of the machine. Jeff Becker ----- Original Message ----- From: "Begat" <bega...@gmail.com> To: "Legacy Ornamental Mills" <legacy-ornamental-mills@googlegroups.com> Sent: Friday, February 17, 2012 4:15:28 AM Subject: Re: What the World Needs Now: TK Extra Large Pilaster Dogs See, Tim, that's what the world was looking for!!! I can't wait to try those out with some wood from home depot. Begat On Feb 16, 10:01 pm, "Tim Krause" <artmarb...@comcast.net> wrote: > Ok, welcome to the world a 6" and 5" pilaster dog set. You have to have > these in your hands to appreciate the mass and size of these things. > > -Tim > > 6and5pilaster_dog.jpg > 33KViewDownload -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.
