Thanks Joe! Like I wrote earlier, it appears I'm going to have problems finding the Community Repeater supplement... If you can help me with that, I'd be much obliged!
I actually have several 4-User Control cards and more tone reeds, so I could potentially have up to maybe 10 or 12 PL codes available. Not sure if I'm going to do that or not at this point (the main question would be why) but I need to use at least one of the 4-User cards, as that is all I have for PL decode/encode... (I see that I can disable the various tones via switches on the front of the card, but as it sits right now, I can only disable ONE of the tones - the others decode and the repeater keys whether the switch is "on" or "off". I'll check for the other mods you speak of. Mark - N9WYS -----Original Message----- From: Repeater-Builder@yahoogroups.com On Behalf Of Joe Burkleo Mark, It sounds like you may be missing the modifications on the interconnect boards for "and squelch". If the audio/squelch board has been modified for "and" squelch and the interconnct board changes have not been made, you will have repeat audio in "PL Disable" or carrier squelch mode and no repeat audio in "PL Mode". Not sure if that is your problem, but it is one of the many things that will cause no repeat audio in the PL Enable Mode with a Micor station. I do not have my manuals in front of me, but this information is in the supplement for the station chassis that covers the backplane and the accessory cards. As was also suggested the Community Repeater manual will be your best friend, if you are going to be running the station in that configuration, as there are several differences between a standard repeater configuration and the community repeater configuration. If everything is properly configured the 4 user PL card should do both PL tone decode and encode. If you have trouble finding the information let em know and I can dig out my manual when I am in the shop tomorrow. Good luck with your project. Joe - WA7JAW
