And don't forget to callibrate for Temperature!!
                               gm..

Wayne Fugitt wrote:
> 
> Evening Ole Bob,
> 
>  >>I make my readings with a 1 cm X 1 cm X 1cm probe (hoem made with brass
> >electrodes). Powered by a regulated
> >10 v ac supply and I measure the ac current. When all of the math is wrung 
> >out
> >one ma is one microSeimen per cc.
> 
>    Gee, that sounds simpler and much more fun.
> 
>    What kind of meter do you use to measure?   Just any good VOM should
> do.  A dedicated current meter of
> 0 to 25 ma would be nice.
> 
>    The  1 ma = 1 microSeimen  is linear I trust,  10 = 10 , ect.
> 
>     The 1 cm cube has a wire attached ?  Any particular type wire, ga,
> strands, ect?
> 
>     I still have a few digital meters ( led type ) that have 3/4 inch tall
> numbers.  These have exceptional calibration and several levels of
> input.  I could dedicate one of these for that task.  I don't think the
> calibration would be too hard.
> 
> Might have to wind a shunt or make one.  These meters are actually
> voltmeters.  I used them to show mmHg from a low pressure transducer in a
> medical product I used to build.
> 
>    I suppose the probes could vary a bit if the calibration would
> compensate for this.
> 
>    Likely you arrived at all this to make the 1 =1.  That was not an
> accident of couse.
> 
>    Once I built a liquid level indicator from an array of transistors and
> voltage dividers.  The capacity was 5 ounces.
> 
>    I had  0 to 5 volts and several of the levels produced 1 volt for one
> ounce.  Due to the fact I was using software with the 0 to 5 V analog
> input, I could do the scale factors for the levels that did not hit the 1
> volt to one ounce.
> 
>    As we know, some of this is limited only by the imagination.
> 
>    Wayne
> 
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
> 
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
> 
> To post, address your message to: [email protected]
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>