Hi Adriaan, The behaviour of the "Enable Tx" button has changed slightly in v1.5. It now toggles on and off automatic transmission. If you turn off automatic transmission during a transmit period the current transmission will finish normally. If you wish to interrupt the current transmission immediately please use the "Halt Tx" button.
This change was made to facilitate another feature allowing the end of QSO action to be simplified with the choice of returning to receive or to re-enable automatic transmission ready for a new CQ call. The point being that this decision can now be made as soon as you have triggered the last message of a QSO rather than having to wait a full minute for it to finish. I hope that is clear? If this is not the behaviour you are seeing please get back to us and we will investigate further. 73 Bill G4WJS. On 10/06/2015 22:13, Joe Taylor wrote: > Hi Adrian, > > We are aware that some users (not all) experience this problem. We are > looking into it. > > -- 73, Joe, K1JT > > On 6/10/2015 4:59 PM, PE2K wrote: >> Dear OM, >> >> In JT vers X 1.50 i make a transmitting in JT9, but when i do a disable >> TX, the transmitting is not stopping but stays on. The red Enable TX >> goes from red to blank. Is this a new setting , with 1.40 i had not that >> problem. The version i use is the one of your webpage. >> >> 73, Adriaan PE2K > > > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
