On 10/06/2015 23:28, Rex wrote: > Hi All Hi Rex, > > From my testing here on both XP and Win7 operating systems the "Enable > Tx" and "Halt Tx" buttons do now work as Bill describes. I am using > r5567. I think the confusion arises because the Tx: "Message" indicator > at the left hand bottom of the main window stays on after "Halt Tx" is > pressed (until the end of that TX period) which makes you think it is > still transmitting. However, if you listen to the tones you will find it > has actually stopped. That is certainly a defect. If you are using VOX for PTT you would not have a serious problem but I suspect any PTT switching is doing the same as the status indicator which is more serious.
I am not able to reproduce that in the current development version. I will check later in v1.5.0 and get back to you for more detailed steps if I can't get it there. Thanks for checking this out. > > Probably useful to have a minor fix to turn off the bottom left hand TX: > "message" indicator at the same time as the tones are turned off. > > Rex VK7MO 73 Bill G4WJS. > > > On 11/06/2015 7:27 AM, Bill Somerville wrote: >> Hi Adriaan, >> >> The behaviour of the "Enable Tx" button has changed slightly in v1.5. It >> now toggles on and off automatic transmission. If you turn off automatic >> transmission during a transmit period the current transmission will >> finish normally. If you wish to interrupt the current transmission >> immediately please use the "Halt Tx" button. >> >> This change was made to facilitate another feature allowing the end of >> QSO action to be simplified with the choice of returning to receive or >> to re-enable automatic transmission ready for a new CQ call. The point >> being that this decision can now be made as soon as you have triggered >> the last message of a QSO rather than having to wait a full minute for >> it to finish. >> >> I hope that is clear? If this is not the behaviour you are seeing please >> get back to us and we will investigate further. >> >> 73 >> Bill >> G4WJS. >> >> On 10/06/2015 22:13, Joe Taylor wrote: >>> Hi Adrian, >>> >>> We are aware that some users (not all) experience this problem. We are >>> looking into it. >>> >>> -- 73, Joe, K1JT >>> >>> On 6/10/2015 4:59 PM, PE2K wrote: >>>> Dear OM, >>>> >>>> In JT vers X 1.50 i make a transmitting in JT9, but when i do a disable >>>> TX, the transmitting is not stopping but stays on. The red Enable TX >>>> goes from red to blank. Is this a new setting , with 1.40 i had not that >>>> problem. The version i use is the one of your webpage. >>>> >>>> 73, Adriaan PE2K >>> ------------------------------------------------------------------------------ >>> _______________________________________________ >>> wsjt-devel mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> ------------------------------------------------------------------------------ >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> > > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
