On 11/06/2015 05:50, Charles Suckling wrote: > Hi Bill Hi Charlie, > > Just to be clear, is the function of the Enable TX and Halt TX in 1.6.0 > supposed to be as described in the 1.6.0 User Guide: > > " Tx toggles the program into automatic T/R sequencing mode and highlights > the button in red. A transmission will start at the beginning of the > selected (odd or even) sequence, or immediately if appropriate. A > transmission will not be started any later than 24 s into a UTC minute. > > Halt Tx terminates a transmission in progress and disables automatic T/R > sequencing." That is basically correct except that for the moment I believe the development code has a check removed that disables late starts to transmissions. This is for testing convenience and will be probably be returned to enabled before release since starting late doesn't have the possibility of decode at the DX end. The 24s time point is probably not correct for WSPR modes although that is probably not important. > > Charlie 73 Bill G4WJS. > > > > > -----Original Message----- > From: Bill Somerville [mailto:[email protected]] > Sent: 10 June 2015 22:28 > To: WSJT software development; PE2K > Subject: Re: [wsjt-devel] JT 1.50 > > Hi Adriaan, > > The behaviour of the "Enable Tx" button has changed slightly in v1.5. It > now toggles on and off automatic transmission. If you turn off automatic > transmission during a transmit period the current transmission will > finish normally. If you wish to interrupt the current transmission > immediately please use the "Halt Tx" button. > > This change was made to facilitate another feature allowing the end of > QSO action to be simplified with the choice of returning to receive or > to re-enable automatic transmission ready for a new CQ call. The point > being that this decision can now be made as soon as you have triggered > the last message of a QSO rather than having to wait a full minute for > it to finish. > > I hope that is clear? If this is not the behaviour you are seeing please > get back to us and we will investigate further. > > 73 > Bill > G4WJS. > > On 10/06/2015 22:13, Joe Taylor wrote: >> Hi Adrian, >> >> We are aware that some users (not all) experience this problem. We are >> looking into it. >> >> -- 73, Joe, K1JT >> >> On 6/10/2015 4:59 PM, PE2K wrote: >>> Dear OM, >>> >>> In JT vers X 1.50 i make a transmitting in JT9, but when i do a disable >>> TX, the transmitting is not stopping but stays on. The red Enable TX >>> goes from red to blank. Is this a new setting , with 1.40 i had not that >>> problem. The version i use is the one of your webpage. >>> >>> 73, Adriaan PE2K
------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
