On 11/06/2015 11:13, [email protected] wrote: > Hi Bill Hi Charlie, > > Thanks - so an observation of Halt TX not cancelling TX Enable (ie TX > Enable staying red after TX Halt is pressed) is not the intended operation > of Halt TX? Correct. > > Understand about late starts not being able to be decoded, but having this > allowed as at present is very useful in other ways. Understood and I can see that on bands where QSO partners may well have a frequency to themselves any transmission might be of use whether it can be decoded or not. > > 73 > > Charlie 73 Bill G4WJS. > > > On 11/06/2015 05:50, Charles Suckling wrote: >>> Hi Bill >> Hi Charlie, >>> Just to be clear, is the function of the Enable TX and Halt TX in 1.6.0 >>> supposed to be as described in the 1.6.0 User Guide: >>> >>> " Tx toggles the program into automatic T/R sequencing mode and >>> highlights >>> the button in red. A transmission will start at the beginning of the >>> selected (odd or even) sequence, or immediately if appropriate. A >>> transmission will not be started any later than 24 s into a UTC minute. >>> >>> Halt Tx terminates a transmission in progress and disables automatic T/R >>> sequencing." >> That is basically correct except that for the moment I believe the >> development code has a check removed that disables late starts to >> transmissions. This is for testing convenience and will be probably be >> returned to enabled before release since starting late doesn't have the >> possibility of decode at the DX end. The 24s time point is probably not >> correct for WSPR modes although that is probably not important. >>> Charlie >> 73 >> Bill >> G4WJS. >>> >>> >>> >>> -----Original Message----- >>> From: Bill Somerville [mailto:[email protected]] >>> Sent: 10 June 2015 22:28 >>> To: WSJT software development; PE2K >>> Subject: Re: [wsjt-devel] JT 1.50 >>> >>> Hi Adriaan, >>> >>> The behaviour of the "Enable Tx" button has changed slightly in v1.5. It >>> now toggles on and off automatic transmission. If you turn off automatic >>> transmission during a transmit period the current transmission will >>> finish normally. If you wish to interrupt the current transmission >>> immediately please use the "Halt Tx" button. >>> >>> This change was made to facilitate another feature allowing the end of >>> QSO action to be simplified with the choice of returning to receive or >>> to re-enable automatic transmission ready for a new CQ call. The point >>> being that this decision can now be made as soon as you have triggered >>> the last message of a QSO rather than having to wait a full minute for >>> it to finish. >>> >>> I hope that is clear? If this is not the behaviour you are seeing please >>> get back to us and we will investigate further. >>> >>> 73 >>> Bill >>> G4WJS. >>> >>> On 10/06/2015 22:13, Joe Taylor wrote: >>>> Hi Adrian, >>>> >>>> We are aware that some users (not all) experience this problem. We are >>>> looking into it. >>>> >>>> -- 73, Joe, K1JT >>>> >>>> On 6/10/2015 4:59 PM, PE2K wrote: >>>>> Dear OM, >>>>> >>>>> In JT vers X 1.50 i make a transmitting in JT9, but when i do a >>>>> disable >>>>> TX, the transmitting is not stopping but stays on. The red Enable TX >>>>> goes from red to blank. Is this a new setting , with 1.40 i had not >>>>> that >>>>> problem. The version i use is the one of your webpage. >>>>> >>>>> 73, Adriaan PE2K
------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
