On 19/07/2021 22:12, Bill Somerville via wsjt-devel wrote:
On 19/07/2021 19:19, Conrad PA5Y via wsjt-devel wrote:
Probably best if I add a few snips. The first configuration works
perfectly. However, in this mode using USB you must select Rear/Data
as the TX audio source. I wish to use the REMOTE SOCKET PTT as the
radio goes over last from a sequencer as is often the case for VHF
ops. I have always run this way. BUT the Transmit audio source is
disabled when you use RTS. The PTT works but I can no longer access
the USB input, this is a BIG problem for me. Why can I not select the
transmit audio source?
I think that this is a HAMLIB bug. How long does it take to fix these
things generally as I assume that this is a Hamlib problem?
Regards
Conrad PA5Y
Conrad,
it seems you have not understood the purpose of the transmit audio
source option in WSJT-X. It is available for rigs like the TS-890s
which have a CAT PTT command (TX) that has two variants to select the
Tx audio source. If you are not using CAT PTT then WSJT-X via Hamlib
cannot use the TX CAT command, because you have explicitly told it not to.
Regardless of the above, the pin you to key the rig also has the same
function, if you use the PTT pin then the audio source is the mic
socket, if you use the PKS pin on the ACC socket then the Tx audio
source is the PKD pin on the same socket.
So in summary, it is down to you to wire the PTT to the correct pin on
the rig, neither WSJT-X nor Hamlib can do that for you!
73
Bill
G4WJS.
Conrad,
also see chapter 8 of your rig's user manual, the section titled
"Configuration of the Input Path of TX Audio". It looks to me that the
audio source is fully configurable for both non-DATA modes and DATA
modes. I don't see why you are having any issues.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel