Hi Conrad,
it is a complex rig!
I suspect that using SS for PTT is not a good idea, that probably leaves
the speech audio processing etc. in circuit. PKS probably doesn't.
73
Bill
G4WJS.
On 19/07/2021 23:02, Conrad PA5Y via wsjt-devel wrote:
It is possible, I completely misunderstood that table and feel very
stupid!
I thought that the top row selected the PTT method and that the bottom
row the audio source, it does not mean that at all 😊If you use SS as
SEND/PTT then set the top row (not the bottom) row to USB Audio, it’s
that simple.
I’ll go away now…….
73
Conrad PA5Y
*From:*Bill Somerville via wsjt-devel <wsjt-devel@lists.sourceforge.net>
*Sent:* 19 July 2021 23:42
*To:* wsjt-devel@lists.sourceforge.net
*Cc:* Bill Somerville <g4...@classdesign.com>
*Subject:* Re: [wsjt-devel] very infuriating problem with Hamlib for
TS-890S
On 19/07/2021 22:12, Bill Somerville via wsjt-devel wrote:
On 19/07/2021 19:19, Conrad PA5Y via wsjt-devel wrote:
Probably best if I add a few snips. The first configuration
works perfectly. However, in this mode using USB you must
select Rear/Data as the TX audio source. I wish to use the
REMOTE SOCKET PTT as the radio goes over last from a sequencer
as is often the case for VHF ops. I have always run this way.
BUT the Transmit audio source is disabled when you use RTS.
The PTT works but I can no longer access the USB input, this
is a BIG problem for me. Why can I not select the transmit
audio source?
I think that this is a HAMLIB bug. How long does it take to
fix these things generally as I assume that this is a Hamlib
problem?
Regards
Conrad PA5Y
Conrad,
it seems you have not understood the purpose of the transmit audio
source option in WSJT-X. It is available for rigs like the TS-890s
which have a CAT PTT command (TX) that has two variants to select
the Tx audio source. If you are not using CAT PTT then WSJT-X via
Hamlib cannot use the TX CAT command, because you have explicitly
told it not to.
Regardless of the above, the pin you to key the rig also has the
same function, if you use the PTT pin then the audio source is the
mic socket, if you use the PKS pin on the ACC socket then the Tx
audio source is the PKD pin on the same socket.
So in summary, it is down to you to wire the PTT to the correct
pin on the rig, neither WSJT-X nor Hamlib can do that for you!
73
Bill
G4WJS.
Conrad,
also see chapter 8 of your rig's user manual, the section titled
"Configuration of the Input Path of TX Audio". It looks to me that the
audio source is fully configurable for both non-DATA modes and DATA
modes. I don't see why you are having any issues.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
