Hello Jarno. I use an RX/TX sequencer. When I TX the station controller/ sequencer takes input from a footswitch (for SSB), WSJT-X via a com port to gnd to TX or a Winkeyer. The sequencer is as follows. Relay is energised on RX.
1. RX/TX masthead relay 2. LNA power 3. Transverter (if used) 4. PA PTT 5. Radio TX This way when I TX all bands LNAs are protected. I only operate on 6m, 4m,2m, 70cms and 23cms. I can also individually switch the relays and LNA voltage off. I run EME on 2m and (soon) 70cms so it is important to provide this level of protection. I have no RS232 from the sequencer on GND on TX so I use the SS input. I had misunderstood the modulation source settings, now all is working as expected. 73 Conrad PA5Y -----Original Message----- From: jarmo via wsjt-devel <wsjt-devel@lists.sourceforge.net> Sent: 20 July 2021 07:34 To: wsjt-devel@lists.sourceforge.net Cc: jarmo <oh1...@nic.fi> Subject: Re: [wsjt-devel] very infuriating problem with Hamlib for TS-890S Mon, 19 Jul 2021 21:48:01 +0000 Conrad PA5Y via wsjt-devel <wsjt-devel@lists.sourceforge.net> kirjoitti: > So why does the WSJT-x software work exactly as I want using the USB > codec in and out on the K3S? Is it because in the K3S CAT commands > there is no possibility to use transmit audio source and so therefore > it does not matter? > > I can key the K3S using the PTT or CAT and still have USB audio. > > I have full CAT control and use RTS for PTT. This keys the rig and the > TX audio goes via the internal USB audio codec. Just like I want it > to. It would be more flexible to let the user choose what happens. > However Kenwood have decided to disable the USB input if the SS (PTT) > is used. There is no way that I can see to use non-CAT PTT and USB > Audio in the TS-890S configuration. This is an oversight by Kenwood. > The rig has hundreds of options but using PTT via the accessory socket > while still using USB audio is not one of them. > > Currently I am using audio from a UMC202HD soundcard via the ACC2 > socket, I really did not want to do that. I do not like to use CAT PTT > to drive the sequencer, but I may have to. It is far better to have > the RF drive go over last – always. > > Anyway, it seems that WSJT-X is behaving correctly and that the > TS-890S has limitations. So wrong email reflector. > > 73 > > Conrad PA5Y I use TS-890S and it works without any problems. Hamlib2 rigctl. Cat control via RS-232 PTT-Method VOX, MODE USB, SPLITOP. FAKEIT So, why not use RS-232? Jarmo _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
