I've found that there are additional filters that translate the #fieldname# from the SYS:form into the $fieldname$ variables that we're use to seeing.
For example, take a look at this filter: NTE:SHR:TranslateNotificationMessageINC1_100 It very well could be the one that you need to modify for your change. Hope that helps, LisaD -----Original Message----- From: Action Request System discussion list(ARSList) [mailto:[EMAIL PROTECTED] On Behalf Of T. Dee Sent: Tuesday, May 13, 2008 2:45 PM To: arslist@ARSLIST.ORG Subject: Question: SYS:Notification Messages I wanted to add another field (Change Type) to one of the out of the box Notifications, so I added the field to: SYS:Form Field Selection The field shows up in the pull down menu in SYS:Notification Messages - however, when the notification goes out it is just showing as #Change Type#. Any ideas why? Thanks! ________________________________________________________________________ _______ UNSUBSCRIBE or access ARSlist Archives at www.arslist.org Platinum Sponsor: www.rmsportal.com ARSlist: "Where the Answers Are" This message is subject to and does not create or vary any contractual relationship between TuringSMI, SMI Technologies, SMI Telco, its subsidiaries or affiliates and you. Internet communications are not secure and therefore the TuringSMI Group does not accept any legal responsibility for the contents of this message. Any views or opinions expressed are those of the author. This message is intended for the addressee(s) only and its contents and any attached files are strictly confidential. If you have received it in error, please contact the sender on the number above. _______________________________________________________________________________ UNSUBSCRIBE or access ARSlist Archives at www.arslist.org Platinum Sponsor: www.rmsportal.com ARSlist: "Where the Answers Are"
