Hi John,
I am not sure as I have not investigated this issue yet. It is easy
enough to check, select "Cumulative" for the 2D spectrum display,
restart WSJT-X, and see if the iusse goes away.
73
Bill
G4WJS.
On 06/03/2021 13:25, John Stengrevics wrote:
Hi Bill,
Will this fix solve the problem I reported yesterday with OS Big Sur?
I’ll repost below in case you didn’t see it.
Thanks,
John
WA1EAZ
Repost - some additions in red:
John & Joe,
I had been using the previous version successfully on a MacBook Pro
(Intel not M1) OS Big Sur 11.2.2.
Today, I downloaded Mac version 2.4.0-rc2.
When running Q65, T/R = 30 seconds, Submode A, the program continues
to transmit after the 30 second period is complete for 60 seconds
total. However, it does not seem to drive my amplifier after 30
seconds.[PTT is activated for the second 30 seconds, but no audio to
drive the amp.] I have since tried FT8 on WSJT-X and can confirm that
it works as usual. Thus, the problem seems to be isolated to Q65.
I did follow the instructions in the Readme file.
If there is a file I can send you, please let me know.
I would appreciate any suggestions you can provide.
Best 73,
John
WA1EAZ
On Mar 6, 2021, at 5:55 AM, Bill Somerville <g4...@classdesign.com
<mailto:g4...@classdesign.com>> wrote:
Hi Dave and Kevin,
we have finally tracked down the cause of this crash, thanks for your
patience it was not so easy to track down. It is repaired for the
next release, for now if you do not use of the Q65_Sync Wide Graph
synchronization plot the crash will be avoided. Note this is not a
Mac specific issue although it does seem to have the most severe
effects on that platform.
73
Bill
G4WJS.
On 06/03/2021 03:59, David Schmocker wrote:
Hello all,
A second report that mirrors this one: WSJT-X 2.4.0rc2
OS 10.14.6, Mac Mini
Mode Q65, Waterfall Q65_ Sync selected and slow to let go of PTT
line to K3S radio (even after Tx period). (when I go into Radio
Panel, the Test PTT Red bar stays on, won't easily release).
Then when a decode should take place, I get a crash exactly as Kevin
reported with the same exact message as reported below.
Thank you, 73,
Dave KJ9I
On 3/5/21, 8:47 PM, "Kevin McQuiggin"<mcqui...@sfu.ca
<mailto:mcqui...@sfu.ca>> wrote:
Hi All:
I tried submitting this earlier today, but it didn’t seem to
make to the list. Hence, a re-submission:
Just trying out RC2 on an iMac, MacOS version 10.14.6 Mojave.
Selection of “Q65_Sync” from dropdown box on the wide graph
causes a crash as soon as the application starts to TX. Selection
of “Cumulative” (the default) and TX/RX are normal.
Specific exception was "EXC_BAD_ACCESS (SIGSEGV)”.
I have saved the crash dump and can provide as necessary.
73,
Kevin VE7ZD
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
