Also remember only to add the clockrate and bandwidth commands on the router
interfaces acting as DCE ports.
When you do a show int, you can see if it's acting like DCE or DTE.
Hth,
Ole
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Ole Drews Jensen
Systems Network Manager
CCNA, MCSE, MCP+I
RWR Enterprises, Inc.
[EMAIL PROTECTED]
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----Original Message-----
From: Neil Schneider [mailto:[EMAIL PROTECTED]]
Sent: Monday, June 11, 2001 4:48 PM
To: [EMAIL PROTECTED]
Subject: Re: URGENT !!!!!!!!!!!!!!!!!!!!! [7:8061]
Are you using the correct crossover cables?
Neil
""Ravi Varma"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Hi Guys
>
> We have 10 3640 Routers at our place
> the probelm i am facing is that i have to connec all these ten routers
back
> to
> back each router have 2 FE and one T1 (dsu/csu)
>
> When i tried to connect then back to back through the serial line
> using show int
>
> Serial 0/0 down and line protocol DOWn
>
> i had assigned Ip address
> assigned the clock rate 64000
> no shut
> and default encapsultaion (hdlc)
>
> and other i had gone through the same procedure but not assigned the
clock
> rate
>
> can u please help me on that it i have to get it up by evening
>
> Thanking you guys in advance
>
> Regards,
>
> Ravi Varma
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8067&t=8061
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
