> >> with the hostmot2-firmware-3x20-1 deb package installed from > >>> www.linuxcnc.org and trying 3x20-small.ini I now get > >>> http://pastebin.ca/2293883 > >>> > > > Also is it possible you have the 6I68 jumpered to auto load a EEPROM > config? > This might cause that error >
On the 6i68, I have now moved jumper W7 to the Down-position. Is that the correct position for use with linuxcnc/hostmot2? However I see the same output as before (below). Anders Starting LinuxCNC... hm2: loading Mesa HostMot2 driver version 0.15 hm2_pci: loading Mesa AnyIO HostMot2 driver version 0.7 Device Node Path: /devices/pci0000:00/0000:00:01.0/0000:01:00.0/0000:02:04.0 check_device_id PCI_ID: 10B5:9056 10B5:3427 RTAPI_PCI: DeviceID: 10B5 9056 10B5 3427 RTAPI_PCI: Calling driver probe function RTAPI_PCI: Enabling Device 0000:02:04.0 Resource 0: 0xdfa10000 0xdfa101ff 00040200 Resource 1: 0x2000 0x20ff 00040101 Resource 2: 0x2400 0x24ff 00040101 Resource 3: 0xdfa00000 0xdfa0ffff 00040200 Resource 4: (nil) (nil) 00000000 Resource 5: (nil) (nil) 00000000 hm2_pci: discovered 3x20-1.0M at 0000:02:04.0 RTAPI_PCI: Map BAR 3 hm2_3x20.0: /DONE status bit indicates busy at start of programming hm2/hm2_3x20.0: failed to reset fpga, aborting hm2_register hm2_3x20.0: board fails HM2 registration ------------------------------------------------------------------------------ LogMeIn Rescue: Anywhere, Anytime Remote support for IT. Free Trial Remotely access PCs and mobile devices and provide instant support Improve your efficiency, and focus on delivering more value-add services Discover what IT Professionals Know. Rescue delivers http://p.sf.net/sfu/logmein_12329d2d _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
