On 09/14/2011 02:00 PM, Kirk Wallace wrote: > On Wed, 2011-09-14 at 08:56 -0700, doug metzler wrote: > ... snip > >> Andy, is the mesa 5i25 compatible with the CNC4PC pendant? and how >> hard is the mesa to install/configure? Looking at the docs I fear it >> might be another rabbit hole - unless it has a wizard :-) >> > Doug, are you using the pendant with the CNC4PC C22 interface board? > EMC2 can use the CNC4PC pendants, but not directly connected to the > parallel port since the pendant connector pin-out does not match the > parallel port pin functions. The C22 or a custom connection will be > needed to connect the pendant pins to the proper parallel port pins. > > The e-stop and/or enable functions may be an issue too. > > I have one of those CNC4PC/Keling pendants. The e-stop works fine, but I've never been able to get the enable button to work.
Mark ------------------------------------------------------------------------------ Doing More with Less: The Next Generation Virtual Desktop What are the key obstacles that have prevented many mid-market businesses from deploying virtual desktops? How do next-generation virtual desktops provide companies an easier-to-deploy, easier-to-manage and more affordable virtual desktop model.http://www.accelacomm.com/jaw/sfnl/114/51426474/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users