i have a key generator already from linuxcracks
On Sun, 24 Oct 1999, Vic said:
> I wish I knew C better or I would crack the heck out of it
>
> On Sat, 23 Oct 1999, you wrote:
> > Im having trouble installing my sound card aswel...
> > i couldnt get it working in the installation of Red Hat 5.2 or Mandrake 6.1 but
> > when i downloaded OSS on my RH 5.2 box it worked.. it only had about 3 hours on
> > the demo and it expired b4 i could crack it.. i updated the kernel and
> > re-downloaded the new version and it wouldnt work at all.. i thought it would
> > be different in mandrake but its not.. it says more than 1 pnp card was
> > detected and id have to choose it myself from the list.. i tried all the pnp
> > cards i could see and none would work...
> > when i do pnpdump the first few lines say this...
> >
> > # Trying port address 0203
> > # Board 1 has serial identifier 2f ff ff ff ff 81 71 93 04
> >
> > # (DEBUG)
> > (READPORT 0x0203)
> > (ISOLATE PRESERVE)
> > (IDENTIFY *)
> > (VERBOSITY 2)
> > (CONFLICT (IO FATAL)(IRQ FATAL)(DMA FATAL)(MEM FATAL))
> > # or WARNING
> >
> > # Card 1: (serial identifier 2f ff ff ff ff 81 71 93 04)
> > # Vendor Id ADS7181, No Serial Number (-1), checksum 0x2F.
> > # Version 1.0, Vendor version 2.0
> > # ANSI string -->Analog Devices AD1816A<--
> > #
> > # Logical device id ADS7180
> > # Device support I/O range check register
> > # Device supports vendor reserved register @ 0x38
> > # Device supports vendor reserved register @ 0x3a
> > # Device supports vendor reserved register @ 0x3d
> > # Device supports vendor reserved register @ 0x3f
> >
> > i dont understand most of that..
> > anyone know if it will work or i should just buy another sound card..
> >
> > Mr-X-
> >
> > On Sat, 23 Oct 1999, Ernest N. Wilcox Jr. said:
> > > Yup, I think you're right, sorry about that. I think it was pnpdump. It's been a
> > > while since I did the set-up. I had to do it the hard way with RedHat 5.2, but
> > > since using Mandrake 6.0 and 6.1, I have been able to use sndconfig to set up
> > > the card.
> > >
> > > The "no boards found" line tells us that pnpdump is not seeing your card
> > > (obviously). Your sound card has the same chip set as mine. I read somewhere
> > > something about edge detection with respect to setting up the card, so I went
> > > into my BIOS settings, and changed the setting for detection from "level" to
> > > "edge". Then I was able to set up the card.
> > >
> > > I am not a technician, and I have no training whatsoever, so what I usually
> > > do, is a lot of reading, and a lot of trial and error. I think I would check
> > > the BIOS settings to see if your (I can't remember the correct name) detection
> > > mode is set to level detection, or edge detection. I don't know if this setting
> > > really did anything for me or not, but if the pnpdump utility is looking for
> > > edge detection, and the BIOS is set to level detection, then pnpdump may not be
> > > able to "see" the card, hence, the "no boards found" line in the isapnp.conf
> > > file. I'm just shooting in the dark, here. Maybe someone with more know-how can
> > > lend a hand.
> > >
> > > Good luck,
> > >
> > > Ernie
> > >
> > >
> > > On Fri, 22 Oct 1999,R_Yeo wrote:
> > > | "Ernest N. Wilcox Jr." wrote:
> > > |
> > > | > isapnpdump > /etc/isapnp.conf
> > > |
> > > | Got this far, but I think the command was pnpdump. The output file,
> > > | however contains lots of commented out lines. An excerp below:
> > > |
> > > | # Trying port address 03ab
> > > | # Trying port address 03b3
> > > | # Trying port address 03bb
> > > | # Trying port address 03e3
> > > | # Trying port address 03eb
> > > | # Trying port address 03f3
> > > | # No boards found
> > > |
> > > | Where would I go about looking for the addresses for my soundcard and
> > > | FDD? BTW, my soundcard is a Crystal 4232. This is from my
> > > | /var/log/messages:
> > > |
> > > | Oct 22 01:20:39 pc15-gmy kernel: ad1848/cs4248 codec driver Copyright
> > > | (C) by Hannu Savolainen 1993-1996
> > > | Oct 22 01:20:39 pc15-gmy kernel: cs4232: set synthio and synthirq to use
> > > | the wavefront facilities.
> > > | Oct 22 01:20:39 pc15-gmy kernel: YM3812 and OPL-3 driver Copyright (C)
> > > | by Hannu Savolainen, Rob Hooft 1993-1996
> > > |
> > > | Appreciate any further help. Looks like this is a good start so far.
> > > |
> > > | --
> > > | Ronald Yeo
> > > | [EMAIL PROTECTED]
> --
> Vic
> Student Of Linux
