Scott, I didn't say Bandwidth shaping because that's what SimpleTRAP Is they are going to do bandwidth shaping at the AP which is where it belongs by general standards. As for the CPE PPPoE I say this in the unit because I don't want to run into problems and have to install software on the clients computers (They reinstall too often or mess things up that way) so the PPPoE authentication in the CPE would be best I believe.
Chris
-----Original Message-----
From: shoffman [mailto:[EMAIL PROTECTED]]
Sent: Friday, June 20, 2003 1:42 PM
To: [EMAIL PROTECTED]
I am using a Cisco AP350 as my AP and using the SBTotal (and some
outdoors) for CPE. I am trying to fine tune the cisco to interoperate
better with the SB's. One thing that Cisco has is the QoS capabilities
from IEEE 802.11e. :
QoS Basis Service Set (QBSS)-Based on IEEE 802.11e DRAFT version 3.3
The issue is, if I have the AP350 broadcast this info, will the SB's use
it? or should I just turn that off to conserve on overhead?
Thanks
Scott Hoffman
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://198.63.203.6
