[smartBridges] esimpleNMS help please...

[Sevak Avakians]

Anyone?  Help please...

I just installed simpleNMS for the first time and would like to remote manage my network from home.  The setup is as follows:


Internet ---DSL---Linksys Router---APPO1----CPEs
                                              |--APPO2---CPEs
                                              |--APPO3...etc.

I've done the following to the Linksys:
1. Disabled "Block WAN requests" in filter section
2. Enabled Multicast Pass Through, IPSec Pass Through, PPTP Pass Through, Remote Management, Remote Upgrade, MTU
3. Port forwarding of port 161 to router IP (both TCP and UDP protocols checked) in Forwarding section
4. Port forwarding of port 162 to router IP (both TCP and UDP protocols checked) in Forwarding section

I've got my WAN address from the "Status" page.  This is the address I put into the Device->Network Scan->Start IP address.  In the Subnet Mask, I put my subnet 255.255.etc.

However, I still can't see any of my sB devices.  Program says "Scanning network..." forever.

What am I doing wrong here?

Thanks,
Sevak