I believe that even with a deluge system you have to install heads per the listing. So you couldn't do his method anyway.
Tell him to seal it all off and use FM200. That may cost a fortune but you have to pay for what you want. Travis Mack, SET MFP Design, LLC www.mfpdesign.com Sent on the Sprint® Now Network from my BlackBerry® -----Original Message----- From: Greg McGahan <[email protected]> Sender: [email protected] Date: Thu, 02 Dec 2010 16:46:25 To: <[email protected]> Reply-To: [email protected] Subject: difficult one The situations is this: Preface - I have already exhausted the "you can't because" in trying to convince him to run two lines exposed in this space. Light Hazard Corridor / Lobby with a center section Sloped, exposed construction 8 in on 12in - 20' in width On each side the ceiling drops about 4' to smooth flat ceilings The architect wants to find a way to eliminate exposed pipe. He prefers to use sidewalls on the vertical 4' sides which I told him we could not do.. His question is can he install detection at the peak, use sidewalls as described above with a deluge valve. Does anyone have any other creative ideas for this situation? Thanks, Greg -- Greg C. McGahan Living Water Fire Protection, LLC. 1160 McKenzie Road Cantonment, FL 32533 850-937-1850 Fax 850-937-1852 _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
