Thanks for the response Asif,

I did, indeed, wipe the negative electrode silver clean mid-cycle. I think,
all-in-all it was a pretty successful batch and I had my first ³swallow²
this morning. I took about 1/2 ounce shot, held it in my mouth for about 5
min and then swallowed. No immediate reactions. I have a wart on one finger
that I will be watching as sort of the ³test results area.² I am generally
healthy however and wonder what sort of initial program dosage I should go
on. I was planning on 1 ounce daily (1/2 morn and 1/2 night). Any thoughts
or suggestions on this?

Thanks again to all,
CT



> I would decant into the final vessel and stop just before the sludge starts
> pouring out.
> I do not believe the floaters at the top should be a problem
> Also make sure you wipe and clean your electrodes even mid cycle so that the
> sludge is at a minimum
> If you're excessively creating sludge then you may wish to lower your current
> a bit.  I would go no higher than 1ma per square inch squared maximum.
> For example I brew with a 6 inch squared surface area and I brew at 2.5 ma
> roughly with constant current control. And it doesn't turn yellow, however
> whenever I approach 1ma per square inch squared then the liquid will colour
> slightly towards amber.
> 
> Sent from my iPhone
> 
> On 10 Mar 2012, at 15:43, "CT" <ch...@saucyenterprizes.com> wrote:
> 
>> First Batch of CS Hello all,
>> 
>> I just made my first batch of CS. I think it came out pretty good, but now I
>> am left with a quandary: I have some thick silvery sludge at the bottom of my
>> jar and some smaller flakey silver floating on top of the CS liquid. I don¹t
>> have any ³approved² filtration method in place and I would like to decant the
>> liquid, however I am tempted to paper-towel the top of the liquid to remove
>> the flakey pieces. I think I can decant without getting any of the bottom
>> sludge into the new container.
>> 
>> Any advice would be very appreciated.
>> 
>> Thanks,
>> Chris Thomas 
>