A friend in MO called me a month or so ago all excited.  She has had her 
numerous warts cut off, burned off & administered all manner of natural 
treatments  to no avail, however, she tried generic brand Preparation H at 
night with a glove over her hand and they finally withered away with no pain 
involved.  Who would have thought it?

Edith


-----Original Message-----
From: Jane MacRoss <highfie...@internode.on.net>
To: silver-list <silver-list@eskimo.com>
Sent: Sat, Mar 10, 2012 3:20 pm
Subject: Re: CS>First Batch of CS/warts


Thuja tincture soaked dressing covered with a light & waterproof tape for 6 
weeks usually works & possibly Biotin will also work removing warts.
 
Jane

----- Original Message ----- 
From: Asif Nathekar 
To: silver-list@eskimo.com 
Sent: Sunday, March 11, 2012 6:01 AM
Subject: Re: CS>First Batch of CS


There are various treatments for warts which have been discussed previously 
including electrical based devices. Worth a look through the archives









On 10 Mar 2012, at 17:26, CT <ch...@saucyenterprizes.com> wrote:




Thanks for the response Asif,

I did, indeed, wipe the negative electrode silver clean mid-cycle. I think, 
all-in-all it was a pretty successful batch and I had my first “swallow” this 
morning. I took about 1/2 ounce shot, held it in my mouth for about 5 min and 
then swallowed. No immediate reactions. I have a wart on one finger that I will 
be watching as sort of the “test results area.” I am generally healthy however 
and wonder what sort of initial program dosage I should go on. I was planning 
on 1 ounce daily (1/2 morn and 1/2 night). Any thoughts or suggestions on this?

Thanks again to all,
CT




I would decant into the final vessel and stop just before the sludge starts 
pouring out.
I do not believe the floaters at the top should be a problem
Also make sure you wipe and clean your electrodes even mid cycle so that the 
sludge is at a minimum
If you're excessively creating sludge then you may wish to lower your current a 
bit.  I would go no higher than 1ma per square inch squared maximum.
For example I brew with a 6 inch squared surface area and I brew at 2.5 ma 
roughly with constant current control. And it doesn't turn yellow, however 
whenever I approach 1ma per square inch squared then the liquid will colour 
slightly towards amber. 

Sent from my iPhone

On 10 Mar 2012, at 15:43, "CT" <ch...@saucyenterprizes.com> wrote:


First Batch of CS Hello all,

I just made my first batch of CS. I think it came out pretty good, but now I am 
left with a quandary: I have some thick silvery sludge at the bottom of my jar 
and some smaller flakey silver floating on top of the CS liquid. I don’t have 
any “approved” filtration method in place and I would like to decant the 
liquid, however I am tempted to paper-towel the top of the liquid to remove the 
flakey pieces. I think I can decant without getting any of the bottom sludge 
into the new container.

Any advice would be very appreciated.

Thanks,
Chris Thomas 




No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1913 / Virus Database: 2114/4862 - Release Date: 03/10/12