Satchid, About your last question on materials in CS and CG, I would like to point out that all "lower" metals than silver in CS must be avoided, because silver will be plated on them. Probably that could be the same with gold in CG. It has to do with the position in the sequence of potential (in dutch: spanningsreeks) in chemistry. The "higher" metal replaces the "lower" metal.
But also materials as PVC (C=Chloride) or sulpher containing compounds will react. (Someone in the group asked a few days ago if CS takes away fluoride. It binds to fluoride, like to chloride, bromide, & iodide. These are the halogens and the make badly soluble silversalts. But even they can be soluble at extreme low concentration.) Silver also binds to glass! I used for making CS with 30-40V DC a glass of 330ml, the electrodes hung along the inside. After a number of times the glass turned brownish. Silver had been fixed to the wall and could not be removed with polishing powder. A friendly electronic expert told me that that silver layer on the wall caused the current to pass along the wall instead of through the water. To avoid that flow of current and timely loss of battery capacity, I now use a strip of hard plastic with two 2mm holes about 3,5 cm apart that holds the two electrodes on top of the glass and away from the wall. RB ----- Original Message ----- From: Satchid <satc...@sevaproductions.com> To: *Silver-List* (E-mail) <silver-list@eskimo.com> Sent: Sunday, January 20, 2002 11:34 AM Subject: RE: CS>questions: stir vs. cs circulating > An other suggestion > > Wile I was making my first CG with the under water arc method I > > > noticed what is obvious that the temperature raised fairly quick until a > point that the water was boiling on the tip of the electrodes with big > bubbles. Then I taught why not put a little water pump to pump the water > around to stir up the CS. For Low voltage CS it could only pump around and > for CG it could be followed with a cooler (something like a condenser for > distilled water) to cool the CG. It would solve the stirring problem and > the cooling problem. maybe there are pumps in glass or is inox good? What > materials are acceptable in CG and CS? > > Greeting > Satchid > > -----Original Message----- > From: I Anderson [mailto:i...@win.co.nz] > Sent: zondag 20 januari 2002 7:45 > To: silver-list@eskimo.com > Subject: RE: CS>questions: stir vs. bubble > > > > Connie and Gaston, > > Thanks for taking the time to do those tests and post the results. > > It is obvious that at least some increase in conductivity is found as > a result of bubbling. > It could be, as you add silver ions then further CO2 may be > dissolved, but whether it is worth finding out, I don't know. > In any event, we now know a little more than we did before! > > Regards > Ivan. > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > silver-list-requ...@eskimo.com -or- silver-digest-requ...@eskimo.com > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: silver-list@eskimo.com > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > List maintainer: Mike Devour <mdev...@eskimo.com> > >
